You, as usual, loaded the laundry in the machine, but after a while found that the washing machine constantly draws water, the cycle goes on endlessly and does not end. Why does not stop the set of water in the machine, let’s understand this material.
What you can do yourself
Incorrect connection to the drain. Sometimes the reason for the constant set of water without stopping is in the wrong connection of the drain. If a new or newly installed washing machine constantly draws water, make sure that the drain hose is not below the level of the tank. Otherwise, the water will gravity flow into the drain, and the machine will be forced to catch it. Check the connection and, if necessary, raise the hose just above the level of the tank (about 60 cm from the floor). See your washing machine’s manual for more information on the connection. Or you can use our washing machine connection service.
Possible faults that require washing machine repair oceanside
If the washing machine is normally installed or has been used for a long time without any complaints to work, but suddenly began to get water constantly, it is likely to be broken. According to the experience of Appliance repair oceanside masters, look for the cause of such behavior in the faults of the following units.
Faulty level sensor
This is the node that measures the water level in the washing machine. It is probably stuck in the “empty tank” position, so the water intake does not stop.
The causes of the malfunction may be as follows:
– The level sensor hose is loose or leaking;
– pressure chamber is clogged;
– the level sensor tube is clogged;
– the sensor itself is out of order.
The water supply valve is out of order
This unit consists of the body, membrane, and electromagnetic coil. In normal conditions, the control unit supplies voltage to the coil, it opens the membrane, and water enters the washing machine under the pressure of the water supply. Constant water intake is associated with the failure of the membrane: it is deformed, torn, or cracked, causing water to flow constantly into the machine.
The control module burned out
Probably due to the failure of the control board, the water inlet valve is constantly energized, it is in the open position, and the water is constantly drawn into the machine.
With similar symptoms, individual radio elements, tracks, or contacts in the circuit of the priming valve burn on the board. This occurs due to voltage surges in the network or high humidity.
If your washing machine constantly draws water without stopping, it’s time to call the professionals. Call or book now.
Masters do washing machine repair oceanside any brand, with vertical and horizontal loading. The specialist will arrive promptly: on the day of request or the next. He will make a diagnosis and determine the exact cause of why does not stop the set of water in the washing machine. With your consent, the repair will be carried out immediately.
Contact us
(442) 291-2244
[email protected]
